So even if broadcasters are dragging their feet, HDV camcorder buyers can edit their footage right now. As well as providing sufficient pixels for HDV, this can also be used to capture stills at up to 1, x 1, A MemoryStick duo slot is integrated for storage, with a 16MB card supplied.
In terms of camcorder functionality, Sony appears to have learned from many of the mistakes it made with the DCR-HC Instead of leaving you to access virtually everything through the touch-sensitive LCD, discrete buttons are available for a number of important functions. You can switch the lens ring from controlling focus to zoom.
The latter zooms the image on the LCD screen for easier focusing, although the actual recorded image remains the same. You still need the LCD to access other features, however.
Most annoyingly, the LCD is the only way to configure white balance. But there is one superb feature available from the touch screen — spot focusing and exposure. This allows you to set either of these parameters simply by touching the point in the frame you want to be used as reference.
You really have to see footage from the HC1E to believe just how good it is. With nearly four times as many pixels per frame as regular TV, the detail is absolutely amazing. Even under artificial illumination, results were better than is normally the case for a single-sensor camcorder.
The HC1E does have a couple of real drawbacks, however. By far the biggest is the fact that tapes are loaded from the bottom. The other one is the Sony proprietary accessory shoe. Replace only with part num- ber specified. Check the area of your repair for unsoldered or poorly-soldered connections. Check the entire board surface for solder splashes and bridges. Check the interboard wiring to ensure that no wires are "pinched" or contact high-wattage resistors.
Look for unauthorized replacement parts, particularly transistors, that were installed during a previous repair. Point them out to the customer and recommend their replacement. Look for parts which, through functioning, show obvious signs of deterioration.
The default setting. Page 12 The CHG charge lamp turns off when the battery is fully charged. You cannot use the battery pack NP-FM30 with your camcorder.
Hold the camcorder correctly. Place your hand on the rear side of the LCD panel to support it. Then, touch the buttons displayed on the screen. In that case, charge the rechargeable battery and then set the date and time again p. Otherwise, image data may be damaged. Page Recording Recording Remove the lens cap. Start playing back. Movies Touch , then touch start playback.
Press [ON] to enhance the outline of the subject for easier focusing. Continued To record in mirror mode For how to adjust the volume, see page Page 29 is a reference page. The indicators during recording will not be recorded. Page Searching For The Starting Point You can view about 2 seconds of the scene recorded just before you stopped the tape.
Then, your camcorder is set to the standby. Searching quickly for a desired LINK cable optional. Page 35 Camcorder Type i. LINK jack, the order of priority of the output signals is as follows Page Using The Menu Items Using the menu items Follow the instructions below to use each of the menu items listed after this page.
The indicators in parentheses appear when the items are selected. See page 38 for details on selecting menu items. Page 43 [AUTO]. The motion of the picture may slow down at this time. The number of recordable pictures varies depending on the recording environment. Page Pict. Menu PICT. LINK jack without effect control. Normally select [AUTO].
When the camcorder is connected to another device using an i. LINK jack. The selected signal is recorded or played back.
0コメント